GW Instek GDS-3000 Series Programming Manual - Manual (Page 47)

COMMAND DETAILS
47
Cursor Commands
:CURSor:MODe .......................................................... 47
:CURSor:SOURce ........................................................ 48
:CURSor:H1Position ................................................... 48
:CURSor:H2Position ................................................... 48
:CURSor:HDELta ........................................................ 49
:CURSor:V1Position .................................................... 49
:CURSor:V2Position .................................................... 49
:CURSor:VDELta ......................................................... 50
: CURSor:XY:RECTangular:X:POSition .................. 50
: CURSor:XY:RECTangular:X:DELta ............................ 50
: CURSor:XY:POLar:RADIUS:POSition ..................51
: CURSor:XY:POLar:RADIUS:DELta .............................51
:CURSor:XY:POLar:THETA:POSition ................... 52
:CURSor:XY:POLar:THETA:DELta .............................. 52
:CURSor:XY:PRODuct:POSition ........................... 52
:CURSor:XY:PRODuct:DELta...................................... 53
:CURSor:XY:RATio:POSition ................................ 53
:CURSor:XY:RATio:DELta ........................................... 53
:CURSor:MODe
Set
Query
Description Sets cursor mode to horizontal (H) or horizontal
and vertical (HV).
Syntax :CURSor:MODe {OFF | H | HV | ? }
Parameter OFF Turns the cursors off.
H Turns the horizontal cursors on.
HV Turns horizontal and vertical cursors on.
Return parameter HV Horizontal and vertical cursors are on.
H Horizontal cursors are on.