GW Instek GDS-3000 Series Programming Manual - Manual (Page 75)

COMMAND DETAILS
75
Run Command
:RUN
Set
Description The run command allows the oscilloscope to
continuously make acquisitions (equivalent to
pressing the Run key on the front panel).
Syntax :RUN
Stop Command
:STOP
Set
Description The stop command stops the oscilloscope making
further acquisitions (equivalent to pressing the
Stop key on the front panel).
Syntax :STOP
Single Command
:SINGle
Set
Description The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled. (equivalent to
pressing the Single key on the front panel).
Syntax :SINGle