SilentKnight VisorAlarm Plus 2U - Manual (Page 73)

VISORALARM - Appendices
IV - 71
Doc.DM374-I
Ver.1.0
•
Heartbeat
[H]RLsOKAYs@s[T]
Where:
[H]: 0A hex character (LF) as header
RR: Receiver number
L: Line number
s: Space
@: Supervision character
[T]: 0D hex character (CR) as terminator
NOTE:
The field line number (LINE-ID) of the CONTACT-ID message can be encoded with 3 digits for the
SURGAR MLR2000. For any other emulation the field is encoded with 1 digit.
When the account number of the mIP/IPDACT is of more than 4 digits the following must be
considered:
4 bytes for the LINE-ID 4 bytes for the account
number
The first four digits of the left will be taken as the account number of the Control Unit and they will be
used in the Account field. The up to four digits of the right are used for the value of the field “LINE-
ID”, beginning with the most significant digit. For example, if the account number in the mIP is
A2345678, the field LINE-ID will be:
Emulated receiver LINE-ID
SUR-GAR MLR2000 A23
SURGAR MLR2D A
RADIONICS 6500 A
ADEMCO 685 A
6.2. SIS Software
VisorALARM PLUS 2U is compatible with the SIS automation software for the three emulation
modes (Sur-gard, Radionics 6500 and Ademco 685). To configure the automation software, simply
select the type of receiver from among these three and configure the ‘protocol’ field from the group of
VisorALARM PLUS 2U alarm-receiver parameters and configure the value corresponding to the
selected emulated receiver.