SilentKnight VisorAlarm Plus 2U - Manual (Page 11)

VISORALARM - Introduction
I - 9
Doc.DM374-I
Ver. 1.0
4. Additional Features
In order to simplify installation and updating of the registered mIP/IPDACTs, the IP VisorALARM
PLUS 2U receiver has additional facilities.
To install new mIP/IPDACTs, the Teldat VisorALARM PLUS 2U possesses configuration patterns
associated to installer passwords. These permit you to automatically register new mIP/IPDACTs in
the supported mIP/IPDACT list and at the same time enable the mIP/IPDACT to request the necessary
configuration for start up. The device can simultaneously have multiple patterns; the choice of one or
other depends on the installer password used in the mIP/IPDACT to request the service.
From release 10.1.27 onwards, when a new mIP/IPDACT is registered an event is generated and sent
to the automation software. The code for this event is configurable, default being 633 (Module
Added).
In order to maintain and update the registered mIP/IPDACTs base, the Teldat VisorALARM PLUS
2U has commands available to remotely update one or multiple configuration parameters used by the
mIP/IPDACTs.