SilentKnight VisorAlarm Plus 2U - Manual (Page 43)

VISOR ALARM – Configuration
III - 41
Doc.DM374-I
Ver.1.0
7. Example
The aim of this example is to provide a view on the whole of the mIP/IPDACT installation process
and system behavior during normal operation. The idea is as follows: a traditional security scenario
wishes to adopt the Teldat solution which permits alarms from the control panel to be sent over IP and
similarly supervise the connection.
To do this, a VisorALARM PLUS 2U is installed in the Alarm Receiver Center. The VisorALARM
PLUS 2U operates as a Sur-Gard receiver. The emulated receiver configuration parameters are as
follows: receiver ID is 6, line identifier 10, link-test 120 seconds, serial line is configured at 19200
bauds, 7 data bits, even parity and two stop bits.
On the client side, there is an alarm control panel whose account number is 1234. The mIP/IPDACT
is installed next to this as described in the mIP/IPDACT installation manual. In Figure 8 the
implicated devices are displayed.
Figure 8. Example
The mIP/IPDACTs supervision interval will be one minute i.e. if this interval times out without
received any response, a communication failure alarm is generated in the ARC Automation Software.
As regards the mIP/IPDACTs, you want to use passwords dependent on the account number (the
mIP/IPDACT uses 00ZYXWV99, the VisorALARM PLUS 2U with this mIP/IPDACT uses
987ZZYYXX89, the console password is 5432Z), the number of retries when faced with a
connectivity failure is 4 and the time between retries is one second. The number of retries when there
are problems transmitting alarms is 3. Finally you need to configure the numeration plan value in the
mIP/IPDACTs (number of digits making up a telephone number) to 7. The installer password is
99887766.
a) VisorALARM PLUS 2U initial configuration
Before installing any mIP/IPDACT, you need to configure the VisorALARM PLUS 2U.