Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 96)

Output fields from the show ip pim mcache command (Continued) TABLE 1
Field Description
Flags (explanation of
flags in the OIF
section) Shows the flags set in each of the Outgoing interface in abbreviated string format whose
explanations are as follows. Legend of this shown at the top of each entry
IM - Immediate
IH - Inherited
MJ - Membership Join
MI - Membership Include
ME - Membership Exclude
BR - Blocked due to SG RPT
BA - Blocked due to Assert
BF - Blocked due to Filter
BI - Blocked IIF (Incoming interface) matches OIF
Src-VLAN VLAN associated with the ingress interface.
You can use the following command to filter the output to display only entries that egress port ethernet
1/1.
device#show ip pim mcache receiver ethernet 1/1
You can use the following command to filter the output to display only the Source Specific Multicast
(SSM) routes in the mcache.
device#show ip pim mcache ssm
You can use the following command to filter the output to display only the Sparse Mode routes in the
mcache.
device#show ip pim mcache sparse
You can use the following command to filter the output to display only the Dense Mode routes in the
mcache.
device#show ip pim mcache dense
You can use the following command to filter the output to display only the entries matching a specific
source.
device#show ip pim mcache 1.1.1.1
You can use the following command to filter the output to display only the entries matching a specific
group.
device#show ip pim mcache 239.1.1.1
Displaying information across VRFs
Use the following command to display information across all active VRFs.
Brocade#show ip pim all-vrf
Displaying information across VRFs
94 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02