Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 112)

Output from the show ip pim bsr command (Continued) TABLE 6
This field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP).
NOTE
This field appears only if this device is a candidate BSR.
group prefixes Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
NOTE
This field appears only if this device is a candidate BSR.
Candidate-RP-
advertisement period Indicates how frequently the BSR sends candidate RP advertisement messages.
NOTE
This field appears only if this device is a candidate BSR.
Displaying candidate RP information
To display candidate RP information, enter the following command at any CLI level.
device# show ip pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 207.95.7.1
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60
This example show information displayed on a device that is a candidate RP. The next example shows
the message displayed on a device that is not a candidate RP.
device# show ip pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ip pim [vrf vrf-name ] rp-candidate
This command displays candidate RP information for the VRF instance identified by the vrf-name
variable.
The following table describes the output from this command.
Displaying candidate RP information
110 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02