beautypg.com

Setting the version, Configuring mld parameters at the interface level, Specifying a port version – Brocade FastIron Ethernet Switch IP Multicast Configuration Guide User Manual

Page 202: Specifying a static group

background image

To set the robustness for a specified VRF, enter the following commands.

device(config)# ipv6 router pim vrf blue

device(config-ipv6-pim-router-vrf-blue)# ipv6 mld robustness 3

Syntax: [no] ipv6 router pim [ vrf vrf-name ]

The vrf parameter specifies the virtual routing instance (VRF) specified by the variable vrf-name .

Setting the version

You can use this command to set the MLD version (1 or 2) globally. You can select the version of MLD
by entering a command such as the following.

device(config)# ipv6 mld version 1

Syntax: ipv6 mld version version-number

The version-number variable sets the MLD version. You can specify 1 or 2 for the MLD version.The
default version is 2.

To set the global MLD version for a specified VRF, enter the following commands.

device(config)# ipv6 router pim vrf blue

device(config-ipv6-pim-router-vrf-blue)# ipv6 mld version 1

Syntax: [no] ipv6 router pim [ vrf vrf-name ]

The vrf parameter specifies the virtual routing instance (VRF) specified by the variable vrf-name .

Configuring MLD parameters at the interface level

The following MLD parameters can be configured at the interface level:

Port- version -

Specifying a port version

on page 200

Static-group -

Specifying a static group

on page 200

Tracking -

Enabling MLD tracking on an interface

on page 201

Version -

Setting the version on an interface

on page 201

Specifying a port version

To set the MLD version on a virtual Ethernet interface, enter the following commands as shown
in the example.

device(config)# interface ve 10

device(config-vif-10)# ipv6 mld port-version 2

Syntax: ipv6 mld port-version version-number

Enter 1 or 2 for version-number . Be sure to enter 2 if you want to use source filtering.

Specifying a static group

A multicast group is usually learned when an MLDv1 report is received. You can configure one or
more static groups without having to receive an MLDv1 report.

Setting the version

200

FastIron Ethernet Switch IP Multicast Configuration Guide

53-1003085-02