Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 181)

Syntax: show ipv6 pim [ vrfvrf-name ] interface [ ethernetslot/portnum | loopbacknum | venum ]
The vrf option allows you to display multicast boundary information for the VRF instance identified by
the vrf-name variable.
The ethernet port-number parameter specifies the physical port.
The loopback num parameter specifies the loopback port.
The ve num parameter specifies a virtual interface.
The following table displays the output from the show ip pim interface ethernet command.
Output from the show ipv6 pim interface ethernet command TABLE 27
Field Description
Interface Name of the interface.
Global Address IP address of the interface.
Port Port number of the designated router.
Mode PIM mode.
St State.
TTL Thr Time to live threshold.
Multicast Boundary Multicast boundary, if one exists.
VRF Name of the VRF.
DR Prio Designated router priority.
Override Interval Override interval in milliseconds.
Displaying a list of multicast groups
To display IPv6 PIM group information, enter the show ipv6 pim group command at any CLI level.
device# show ipv6 pim group
Total number of groups: 1
1 Group ff7e:a40:2001:3e8:27:0:1:2
Group member at e3/1: v31
Syntax: show ipv6 pim [ vrf vrf-name ] group
The vrf parameter allows you to display IPv6 PIM group information for the VRF instance identified by
the vrf-name variable.
The following table displays the output from the show ipv6 pim group command.
Displaying a list of multicast groups
FastIron Ethernet Switch IP Multicast Configuration Guide 179
53-1003085-02