Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 135)

MSDP source active cache (Continued) TABLE 16
This field... Displays...
Orig Peer The peer from which this source-active entry was received.
Age The number of seconds the entry has been in the cache
You can use the following command to filter the output to display only the entries matching a specific
source.
device#show ip msdp sa-cache 1.1.1.1
You can use the following command to filter the output to display only the entries matching a specific
group.
device#show ip msdp sa-cache 239.1.1.1
You can use the following command to filter the output to display only the SA cache entries that are
received from peers in the BGP AS Number 100.
device#show ip msdp sa-cache 100
You can use the following command to filter the output to display only the SA cache entries that are
originated by the RP 1.1.1.1.
device#show ip msdp sa-cache orig-rp 1.1.1.1
You can use the following command to filter the output to display only the SA cache entries that are
received from the peer 1.1.1.1.
device#show ip msdp sa-cache peer 1.1.1.1
You can use the following command to display the rejected SAs. You can further narrow down by
quoting the reason for rejection.
device#show ip msdp sa-cache rejected
You can use the following command to display the self-originated SAs.
device#show ip msdp sa-cache self-originated
Displaying MSDP RPF-Peer
To display MSDP peer information for the RP 1.1.1.1, enter the following command.
device# show ip msdp rpf-peer 1.1.1.1
MSDP Peer Status Summary
KA: Keepalive SA:Source-Active NOT: Notification
Peer Address Peer As State KA SA NOT Age
In Out In Out In Out
40.40.40.3 1001 ESTABLISH 62 62 0 0 0 0 7
Brocade#
Syntax: show ip msdp [vrf vrf-name ] rpf-peer ip-addr
Displaying MSDP RPF-Peer
FastIron Ethernet Switch IP Multicast Configuration Guide 133
53-1003085-02