Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 184)

RP: 1be::11:21
group prefixes:
ff00:: / 8
Candidate-RP-advertisement period: 60
This example shows information displayed on a device that is a candidate RP. The following example
shows the message displayed on a device that is not a candidate RP.
device# show ipv6 pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ipv6 pim [ vrf vrf-name ] rp-candidate
The vrf parameter allows you to display IPv6 candidate RP information for the VRF instance identified
by the vrf-name variable.
The following table displays the output from the show ipv6 pim rp-candidate command.
Output from the show ipv6 pim rp-candidate command TABLE 30
Field Description
Candidate-RP-advertisement
in Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE
This field appears only if this device is a candidate RP.
RP Indicates the IPv6 address of the Rendezvous Point (RP).
NOTE
This field appears only if this device is a candidate RP.
group prefixes Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
NOTE
This field appears only if this device is a candidate RP.
Candidate-RP-advertisement
period Indicates how frequently the BSR sends candidate RP advertisement messages.
NOTE
This field appears only if this device is a candidate RP.
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the show ipv6 pim rp-map command at any CLI level.
Brocade#show ipv6 pim rp-map
Number of group-to-RP mappings: 3
-------------------------------------------------------------------------------
S.No Group address RP address
Displaying RP-to-group mappings
182 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02