beautypg.com

Enabling fast convergence, Displaying mld snooping information, Displaying mld snooping error information – Brocade FastIron Ethernet Switch IP Multicast Configuration Guide User Manual

Page 57

background image

Enabling fast convergence

In addition to periodically sending general queries, an active (querier) device sends out general queries
when it detects a new port. However, since it does not recognize the other device port-up event, the
multicast traffic might still use the query-interval time to resume after a topology change. Configuring
fast-convergence allows the device to listen to topology change events in Layer 2 protocols, such as
spanning tree, and send general queries to shorten the convergence time.

If the Layer 2 protocol is unable to detect a topology change, the fast-convergence feature may not
work. For example, if the direct connection between two devices switches from one interface to another,
the rapid spanning tree protocol (802.1w) considers this an optimization action, rather than a topology
change. In this case, other devices will not receive topology change notifications and will be unable to
send queries to speed up the convergence. The original spanning tree protocol does not recognize
optimization actions, and fast-convergence works in all cases.

To enable fast-convergence, enter commands such as the following.

device(config)#vlan 70

device(config-vlan-70)#multicast6 fast-convergence

Syntax: [no] multicast6 fast-convergence

Displaying MLD snooping information

You can display the following MLD snooping information:

MLD snooping error information

Group and forwarding information for VLANs

Information about MLD snooping mcache

MLD memory pool usage

Status of MLD traffic

MLD information by VLAN

Displaying MLD snooping error information

To display information about possible MLD errors, enter the following command.

device#show ipv6 multicast error

snoop SW processed pkt: 173, up-time 160 sec

Syntax: show ipv6 multicast error

The following table describes the output from the show ipv6 multicast error command.

Field

Description

SW processed pkt

The number of IPv6 multicast packets processed by MLD snooping.

up-time

The MLD snooping up time.

Enabling fast convergence

FastIron Ethernet Switch IP Multicast Configuration Guide

55

53-1003085-02