Displaying ipv6 pim interface information – Brocade FastIron Ethernet Switch IP Multicast Configuration Guide User Manual
Page 180
Output from the show ipv6 pim sparse command (Continued)
TABLE 26
Field
Description
Candidate-RP Msg
interval
Number of seconds the candidate RP configured on the Layer 3 switch sends candidate
RP advertisement messages to the BSR. Default is 60 seconds.
Register Suppress
Time
This is the mean interval between receiving a Register-Stop and allowing
registers to be sent again. A lower value means more frequent register bursts at RP, while
a higher value means longer join latency for new receivers. Default: 60 seconds.
Register Probe Time
Number of seconds the PIM router waits for a register-stop from an RP before it generates
another NULL register to the PIM RP. Default is 10 seconds.
Register Stop Delay
Register stop message. Default is 10 seconds.
Register Suppress
interval
Number of seconds that it takes the designated router to send Register-encapsulated data
to the RP after receiving a Register-Stop message. Default is 60 seconds.
SSM Enabled
If yes, source-specific multicast is configured globally on this router.
SPT threshold
Number of packets the device sends using the path through the RP before switching to the
SPT path. Default is 1 packet.
SSM Group Range
Source-specific multicast group range.
Route Precedence
The route precedence configured to control the selection of routes based on the four route
types:
•
Non-default route from the mRTM
•
Default route from the mRTM
•
Non-default route from the uRTM
•
Default route from the uRTM
Embedded RP
Enabled
Indicates whether the embedded RP is enabled or disabled.
Displaying IPv6 PIM interface information
You can display IPv6 PIM multicast interface information using the show ipv6 pim interface
command.
device# show ipv6 pim interface ethernet 1/1/7
Flags : SM - Sparse Mode v2
---------+---------------------------------------------------+----+---+---+---------
+-------+----------------
Interface|Global Address |Mode|St |TTL|
Multicast| VRF | DR | Override
| + Designated Router Port | | |Thr|Boundary
| | Prio | Interval
---------+---------------------------------------------------+----+---+---+---------
+-------+----------------
e1/1/1 a141::1 SM Ena 1 None
default 1 3000ms
+ Itself
Total Number of Interfaces : 1
Displaying IPv6 PIM interface information
178
FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02