Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 210)

Displaying multicast boundaries
To display multicast boundary information, use the show ipv6 pim interface command. In this
example, abc is the name of the access list.
device# show ipv6 pim interface ethernet 1/1/7
Flags : SM - Sparse Mode v2
---------+---------------------------------------------------+----+---+---+---------
+-------+----------------
Interface|Global Address |Mode|St |TTL|
Multicast| VRF | DR | Override
| + Designated Router Port | | |Thr|Boundary
| | Prio | Interval
---------+---------------------------------------------------+----+---+---+---------
+-------+----------------
e1/1/1 a141::1 SM Ena 1 abc
default 1 3000ms
+ Itself
Total Number of Interfaces : 1
Displaying multicast boundaries
208 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02