Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 220)

History
Release version Command history
8.0.10a This command was introduced.
ipv6 mroute next-hop-recursion
Configures the recursion level while using static mroutes to resolve a static mroute next hop.
Syntax ipv6 mroute [ vrf vrf-name ] next-hop-recursion 1-10
no ipv6 mroute [ vrf vrf-name ] next-hop-recursion 1-10
Command Default The recursion level for resolving a static mroute next hop is 3.
Parameters vrf vrf-name
Configures a static mroute for this virtual routing and forwarding (VRF) route.
Modes VRF configuration mode
Usage Guidelines The no form of this command restores the default recursion level for resolving a static mroute next hop.
Examples This example sets the recursion level for resolving a static mroute next hop to 7:
Device(config-vrf)# ipv6 mroute next-hop-recursion 7
This example sets the recursion level for resolving a static mroute next hop to the default value, 3:
Device(config-vrf)# ipv6 mroute next-hop-recursion
This example disables the recursion for resolving a static mroute next hop:
Device(config-vrf)# no ipv6 mroute next-hop-recursion
History
Release version Command history
8.0.10a This command was introduced.
ipv6 multicast disable-flooding
Disables the flooding of unregistered IPv6 multicast frames in an MLD-snooping-enabled VLAN.
Syntax ipv6 multicast disable-flooding
no ipv6 multicast disable-flooding
Command Default The switch floods unregistered IPv6 multicast frames in an MLD-snooping-enabled VLAN.
Modes Global configuration mode
ipv6 mroute next-hop-recursion
218 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02