Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 114)

Output of the show ip pim rp-map command TABLE 8
This field... Displays...
Group address Indicates the PIM Sparse multicast group address using the listed RP.
RP address Indicates the IP address of the Rendezvous Point (RP) for the listed PIM Sparse group.
Displaying RP Information for a PIM Sparse group
To display RP information for a PIM Sparse group, enter the following command at any CLI level.
device# show ip pim rp-hash 239.255.162.1
RP: 207.95.7.1, v2
Info source: 207.95.7.1, via bootstrap
Syntax: show ip pim [vrf vrf-name ] rp-hash group-addr
The vrf option allows you to display RP information for the VRF instance identified by the vrf-name
variable.
The group-addr parameter is the address of a PIM Sparse IP multicast group.
The following table describes the output from this command.
Output from the show ip pim command TABLE 9
This field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP) for the specified PIM Sparse group.
Info source Indicates the source of the RP information. It can be a static-RP configuration or learned via the
bootstrap router. If RP information is learned from the boot strap, the BSR IP address is also
displayed.
Displaying the RP set list
To display the RP set list for the device elected as BSR, enter the following command at any CLI level.
device(config)# show ip pim rp-set
Static RP
---------
Static RP count: 2
1.51.51.4
1.51.51.5
Number of group prefixes Learnt from BSR: 1
Group prefix = 224.0.0.0/4 # RPs: 2
RP 1: 1.51.51.1 priority=0 age=60 holdtime=150
RP 2: 1.51.51.3 priority=0 age=30 holdtime=150
To display the RP set list for devices that are not elected as BSR, enter the following command at any
CLI level.
Brocade(config)# show ip pim rp-set
Static RP
---------
Static RP count: 2
1.51.51.4
1.51.51.5
Displaying RP Information for a PIM Sparse group
112 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02