Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 214)

Configures a virtual interface as the route path.
tunnel num
Configures a tunnel interface as the route path.
cost
Configures a metric for comparing the route to other static routes in the static route table
that have the same destination. The range is 1-16; the default is 1.
distance distance-value
Configures the route's administrative distance. The range is 1-255; the default is 1.
name name
Name for this static route.
Modes VRF configuration mode
Usage Guidelines The no form of this command deletes a previously configured directly connected static multicast route.
Connected routes on PIM enabled interfaces are automatically added to the mRTM table.
Examples This example adds a directly connected mroute to network 10.1.1.0/24 on interface ve 10.
Device(config-vrf)# ip mroute 10.1.1.0 255.255.255.0 ve 10
History
Release version Command history
8.0.10a This command was introduced.
ip mroute (next hop)
Configures a static multicast route with a next hop.
Syntax ip mroute [ vrf vrf-name ] ip-address ip-address mask next-hop address [ cost ] [ distance distance-
value ] [ name name ]
no ip mroute [ vrf vrf-name ] ip-address ip-address mask next-hop address [ cost ] [ distance distance-
value ] [ name name ]
Command Default No next-hop static multicast route is configured.
Parameters vrf vrf-name
Configures a static mroute for this virtual routing and forwarding (VRF) route.
ip-address ip-address mask
The destination IP address and prefix for which the route should be added.
next-hop address
Configures a next-hop address as the route path.
cost
ip mroute (next hop)
212 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02