Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 221)

Usage Guidelines
NOTE
This command is supported only on ICX 6650 devices.
The no form of this command enables the flooding of unregistered IPv6 multicast frames in an MLD-
snooping-enabled VLAN.
After the hardware forwarding database (FDB) entry is made, the multicast traffic is switched only to the
VLAN hosts that are members of the multicast group. This can avoid congestion and loss of traffic on
the ports that have not subscribed to this IPv6 multicast traffic.
Examples The following example shows the disabling of flooding of unregistered IPv6 multicast frames.
Brocade(config)# ipv6 multicast disable-flooding
History
Release version Command history
08.0.01 This command was introduced.
route-precedence
Configures a table that specifies the order in which routes are selected for multicast.
Syntax route-precedence { [ mc-non-default | none ] | [ mc-default | none ] | [ uc-non-default | none ] | [ uc-
default | none ] }
no route-precedence
Command Default The default is route-precedence mc-non-default mc-default uc-non-default uc-default.
Parameters mc-non-default
Specifies precedence for a non-default multicast route table (mRTM).
none
Specifies that certain types of route be ignored.
mc-default
Specifies precedence for an mRTM.
uc-non-default
Specifies precedence for a non-default unicast route table (uRTM).
uc-default
Specifies precedence for a uRTM.
Modes PIM configuration mode
Usage Guidelines The no form of this command removes the configuration and restores the default route precedence
settings.
route-precedence
FastIron Ethernet Switch IP Multicast Configuration Guide 219
53-1003085-02