Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 110)

Group member at e2/9: v59
Group member at e1/16: v57
3 Group 226.0.120.0
Group member at e2/9: v59
Group member at e1/16: v57
4 Group 226.0.163.0
Group member at e2/9: v59
Group member at e1/16: v57
5 Group 226.0.206.0
Group member at e2/9: v59
Group member at e1/16: v57
6 Group 226.0.249.0
Group member at e2/9: v59
Group member at e1/16: v57
7 Group 226.0.30.0
Group member at e2/9: v59
Group member at e1/16: v57
device(config)#
Syntax: show ip pim [vrf vrf-name ] group
The vrf keyword allows you to display PIM group information for the VRF instance identified by the vrf-
name variable.
The following table describes the output from this command:
Output from the show ip pim group command TABLE 5
This field... Displays...
Total number of Groups Lists the total number of IP multicast groups the device is forwarding.
NOTE
This list can include groups that are not PIM Sparse groups. If interfaces on the device
are configured for regular PIM (dense mode), these groups are listed too.
Index The index number of the table entry in the display.
Group The multicast group address
Ports The device ports connected to the receivers of the groups.
Displaying BSR information
To display BSR information, enter the following command at any CLI level.
device(config)# show ip pim bsr
PIMv2 Bootstrap information for Vrf Instance : default-vrf
------------------------------------------------------------------------------
This system is the Elected BSR
BSR address: 1.51.51.1. Hash Mask Length 32. Priority 255.
Next bootstrap message in 00:01:00
Configuration:
Candidate loopback 2 (Address 1.51.51.1). Hash Mask Length 32. Priority 255.
Next Candidate-RP-advertisment in 00:01:00
RP: 1.51.51.1
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60
Displaying BSR information
108 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02