Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 113)

Output from the show ip pim rp-candidate command TABLE 7
This field... Displays...
Candidate-RP-advertisement
in Indicates how time will pass before the BSR sends the next RP message. The time
is displayed in "hh:mm:ss" format.
NOTE
This field appears only if this device is a candidate RP.
RP Indicates the IP address of the Rendezvous Point (RP).
NOTE
This field appears only if this device is a candidate RP.
group prefixes Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
NOTE
This field appears only if this device is a candidate RP.
Candidate-RP-advertisement
period Indicates how frequently the BSR sends candidate RP advertisement messages.
NOTE
This field appears only if this device is a candidate RP.
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
device# show ip pim rp-map
Number of group-to-RP mappings: 6
Group address RP address
-------------------------------
1 239.255.163.1 99.99.99.5
2 239.255.163.2 99.99.99.5
3 239.255.163.3 99.99.99.5
4 239.255.162.1 99.99.99.5
5 239.255.162.2 43.43.43.1
6 239.255.162.3 99.99.99.5
Syntax: show ip pim [vrf vrf-name ] rp-map
The vrf option allows you to display candidate RP-to-group mappings for the VRF instance identified by
the vrf-name variable.
The following table describes the output from this command.
Displaying RP-to-group mappings
FastIron Ethernet Switch IP Multicast Configuration Guide 111
53-1003085-02