Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 225)

Examples This example displays information for configured multicast routes:
Device(config)# show ip static mroute
IP Static Routing Table - 2 entries:
IP Prefix Next Hop Interface Dis/Metric/Tag Name
*20.20.20.0/24 220.220.220.1 - 1/1/0
20.20.20.0/24 50.50.50.2 - 1/2/0
21.21.21.0/24 1.2.3.4 - 1/1/0
History
Release version Command history
8.0.10a This command was introduced.
show ipv6 mroute
Displays information on IPv6 multicast routes. You can specify whether you want to display information
from static or connected mroutes or from a particular mroute.
Syntax show ipv6 mroute [vrf vrf-name ] [ static | connect] | [ ipv6-address ipv6-prefix/prefix-length] [
summary ]
Parameters vrf vrf-name
Specifies displaying mroutes for a particular VRF
ipv6-address ipv6-prefix/prefix-length
Specifies displaying an IPv6 mroute for the specified destination.
static
Specifies displaying only static multicast routes.
connect
Specifies displaying only connected multicast routes.
summary
Specifies displaying summary information.
Modes Privileged EXEC mode
Examples This example displays information for IPv6 multicast routes:
Device(config)# show ipv6 mroute
IPv6 Routing Table - 7 entries:
Type Codes - B:BGP C:Connected S:Static
Type IPv6 Prefix Next Hop Router Interface Dis/Metric Uptime
S 1:1::1:0/120 :: ve 90 1/1 2d16h
C 2090::/64 :: ve 90 0/0 6d21h
C 2100::/64 :: ve 100 0/0 1d21h
C 2110::/64 :: ve 110 0/0 1d21h
C 2120::/64 :: ve 120 0/0 1d21h
C 2130::/64 :: ve 130 0/0 6d21h
C 8811::1/128 :: loopback 1 0/0 6d21h
show ipv6 mroute
FastIron Ethernet Switch IP Multicast Configuration Guide 223
53-1003085-02