Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 36)

default V2
**** Warning! has V3 (age=0) nbrs
group: 234.4.4.4, life = 260
group: 226.6.6.6, life = 260
3/1/1 has 4 groups,
This interface is non-Querier (passive)
default V2
group: 238.8.8.8, life = 260
group: 228.8.8.8, life = 260
group: 230.0.0.0, life = 260
group: 224.4.4.4, life = 260
3/1/4 has 1 groups,
This interface is non-Querier (passive)
Querier is 10.8.8.8
Age is 0
Max response time is 100
default V2
**** Warning! has V3 (age=0) nbrs
group: 236.6.6.6, life = 260
Clear commands for IGMP snooping
The clear IGMP snooping commands must be used only in troubleshooting conditions, or to recover
from errors.
Clearing the IGMP mcache
To clear the mcache on all VLANs, enter the clear ip multicast mcache command.
device#clear ip multicast mcache
Syntax: clear ip multicast mcache
Clearing the mcache on a specific VLAN
To clear the mcache on a specific VLAN, enter the following command.
device#clear ip multicast vlan 10 mcache
Syntax: clear ip multicast vlan vlan-id mcache
The vlan-id parameter specifies the specific VLAN in which the mcache needs to be cleared.
Clearing traffic on a specific VLAN
To clear the traffic counters on a specific VLAN, enter the following command.
device#clear ip multicast vlan 10 traffic
Syntax: clear ip multicast vlanvlan-id traffic
The vlan-id parameter specifies the specific VLAN in which traffic counters needs to be cleared.
Clear commands for IGMP snooping
34 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02