Brocade FastIron Ethernet Switch IP Multicast Configuration Guide - Manual (Page 178)

Join/Prune interval : 60 Inactivity interval : 180
Hardware Drop Enabled : Yes Prune Wait Interval : 3
Bootstrap Msg interval : 60 Candidate-RP Msg interval : 60
Register Suppress Time : 60 Register Probe Time : 10
Register Stop Delay : 10 Register Suppress interval : 60
SSM Enabled : Yes SPT Threshold : 1
SSM Group Range : ff30::/32
Route Precedence : mc-non-default mc-default uc-non-default uc-default
Embedded RP Enabled : Yes
Displaying system values
To display default, maximum, current, and configured values for system maximum parameters, use
the show default values command. The following output example does not show complete output; it
shows only PIM6 hardware mcache values.
device(config)#show default values
System Parameters Default Maximum Current Configured
pim6-hw-mcache 512 1024 1024 1024
Displaying PIM Sparse configuration information and statistics
You can display the following PIM Sparse information:
• Basic PIM Sparse configuration information
• IPv6 interface information
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for an IPv6 PIM Sparse group
• RP set list
• Multicast neighbor information
• The IPv6 PIM multicast cache
• IPv6 PIM RPF
• IPv6 PIM counters
• IPv6 PIM resources
• IPv6 PIM traffic statistics
Displaying basic PIM Sparse configuration information
Enter the show ipv6 pim sparse command at any CLI level to display IPv6 PIM Sparse configuration
information.
Brocade# show ipv6 pim sparse
Global PIM Sparse Mode Settings
Maximum Mcache : 4096 Current Count : 7
Hello interval : 30 Neighbor timeout : 105
Join/Prune interval : 60 Inactivity interval : 180
Hardware Drop Enabled : Yes Prune Wait Interval : 3
Bootstrap Msg interval : 60 Candidate-RP Msg interval : 60
Register Suppress Time : 60 Register Probe Time : 10
Register Stop Delay : 10 Register Suppress interval : 60
SSM Enabled : Yes SPT Threshold : 1
SSM Group Range : ff30::/32
Route Precedence : mc-non-default mc-default uc-non-default uc-default
Embedded RP Enabled : Yes
Displaying system values
176 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02