Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 9)

About This Guide
● Introduction....................................................................................................................... 7
● Audience........................................................................................................................... 8
● What’s new in this document............................................................................................ 8
● Related publications..........................................................................................................8
Introduction
This guide includes procedures for configuring the software. The software procedures show how to
perform tasks using the CLI. This guide also describes how to monitor Brocade products using statistics
and summary screens.
Supported Hardware
This guide supports the following product families from Brocade:
• FastIron X Series devices (chassis models):
‐ FastIron SX 800
‐ FastIron SX 1600
• Brocade FCX Series (FCX) Stackable Switch
• Brocade ICX ™ 6610 (ICX 6610) Stackable Switch
• Brocade ICX 6430 Series (ICX 6430)
• Brocade ICX 6450 Series (ICX 6450)
• Brocade ICX 6650 series (ICX 6650)
• Brocade ICX 7750 series (ICX 7750)
For information about the specific models and modules supported in a product family, refer to the
hardware installation guide for that product family.
Related publications on page 8 lists the hardware
installation guides.
NOTE
• The Brocade ICX 6430-C switch supports the same feature set as the Brocade ICX 6430 switch
unless otherwise noted.
• The Brocade ICX 6450-C switch supports the same feature set as the Brocade ICX 6450 switch
unless otherwise noted.
Unsupported features
Features that are not documented in Related publications on page 8 are not supported.
FastIron Ethernet Switch Software Upgrade Guide 7
53-1003089-02