Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 31)

512 MB DRAM
STACKID 1 system uptime is 3 minutes 39 seconds
The system : started=warm start reloaded=by "reload"
The version information is shown in bold type in this example:
• "07.4.00T311" indicates the flash code version number. The "T311" is used by Brocade for record
keeping.
• "labeled as ICX64S07400" indicates the flash code image label. The label indicates the image type
and version and is especially useful if you change the image file name.
• "Primary ICX64S07400.bin" indicates the flash code image file name that was loaded.
• "License: BASE_SOFT_PACKAGE (LID: dbuFJJHiFFi)" indicates the license currently installed on
the device.
Example for determining the boot image versions
To determine the boot and flash images installed on a device, enter the show flash command at any
level of the CLI. The following shows an example output:
device#show flash
Active Management Module (Slot 9):
Compressed Pri Code size = 3613675, Version 03.1.00aT3e3 (sxr03100a.bin)
Compressed Sec Code size = 2250218, Version 03.1.00aT3e1 (sxs03100a.bin)
Compressed BootROM Code size = 524288, Version 03.0.01T3e5
Code Flash Free Space = 9699328
Standby Management Module (Slot 10):
Compressed Pri Code size = 3613675, Version 03.1.00aT3e3 (sxr03100a.bin)
Compressed Sec Code size = 2250218, Version 03.1.00aT3e1 (sxs03100a.bin)
Compressed BootROM Code size = 524288, Version 03.0.01T3e5
Code Flash Free Space = 524288
• The "Compressed Pri Code size" line lists the flash code version installed in the primary flash area.
• The "Compressed Sec Code size" line lists the flash code version installed in the secondary flash
area.
• The "Compressed BootROM Code size" line lists the boot code version installed in flash memory.
The device does not have separate primary and secondary flash areas for the boot image. The
flash memory module contains only one boot image.
Example for determining the current licenses installed
Use the show version command to display the licenses installed on the device. For example, the
following line from the output of this command lists the license ID.
device#show version
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserved.
UNIT 1: compiled on Mar 2 2012 at 12:38:17 labeled as ICX64S07400
(10360844 bytes) from Primary ICX64S07400.bin
SW: Version 07.4.00T311
Boot-Monitor Image size = 774980, Version:07.4.00T310 (kxz07400)
HW: Stackable ICX6450-24
==========================================================================
UNIT 1: SL 1: ICX6450-24 24-port Management Module
Serial #: BZSXXXXXXXX
License: BASE_SOFT_PACKAGE (LID: dbuFJJHiFFi)
P-ENGINE 0: type DEF0, rev 01
Example for determining the boot image versions
FastIron Ethernet Switch Software Upgrade Guide 29
53-1003089-02