Brocade FastIron Ethernet Switch Software Upgrade Guide User Manual

Page 44

#################################################################

########################################################

done

Bytes transferred = 10360844 (9e180c hex)

prot off f8100000 f907ffff

................................................................................

........

Un-Protected 248 sectors

erase f8100000 f907ffff

.................................................

.................................................................

....

Erased 248 sectors

copying image to flash, it will take sometime...

sflash write 3000000 100000 f80000

TFTP to Flash Done.

12. Load the image from the primary flash using the boot_primary command. For example:

ICX64XX-boot> boot_primary

Booting image from Primary

## Booting image at 00007fc0 ...

Created: 2012-03-02 20:38:52 UTC

Data Size: 10360268 Bytes = 9.9 MB

Load Address: 00008000

Entry Point: 00008000

Verifying Checksum ... OK

Starting kernel in BE mode ...

Uncompressing Image.............................................................

................................................................................

........................................... done, booting the kernel.

Config partition mounted.

13. Enter show flash and see the output to check whether image copy process is successful.
14. Copy the image from primary to secondary flash partition using the copy flash flash secondary

command.

Software Upgrade and Downgrade

FastIron Ethernet Switch Software Upgrade Guide

53-1003089-02