Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 15)

Changes in multicast parameter values (Continued) TABLE 2
Parameter Device FastIron 08.0.xx(minimum/
maximum/default) FastIron 07.4.00(minimum/maximum/
default)
L3 Multicast
IGMP Groups FCX 1/8192/4096 256/8192/4096
ICX 6610 1/8192/4096 256/8192/4096
SX Gen2 1/8192/4096 256/8192/4096
SX Gen3 1/8192/4096 256/8192/4096
PIM (S,G) mcache FCX 256/6144/1024 256/4096/1024
ICX 6610 256/6144/1024 256/4096/1024
SX Gen3 256/6144/1024 256/4096/1024
MSDP SA cache FCX 1024/8192/4096 Not supported in FastIron 07.4.00
ICX 6610 1024/8192/4096 Not supported in FastIron 07.4.00
MLD Groups FCX 1/8192/4096 Not supported in FastIron 07.4.00
ICX 6610 1/8192/4096 Not supported in FastIron 07.4.00
SX Gen2 1/8192/4096 Not supported in FastIron 07.4.00
SX Gen3 1/8192/4096 Not supported in FastIron 07.4.00
PIM6 (S.G) mcache FCX 256/1024/512 Not supported in FastIron 07.4.00
ICX 6610 256/1024/512 Not supported in FastIron 07.4.00
SX Gen3 256/1800/1024 Not supported in FastIron 07.4.00
BGP parameter default values
Changes in BGP, BGP4+, and Route Maps defaults TABLE 3
Parameter FastIron 08.0.xx FastIron 07.4.00 Note
Maximum retry interval 160 NA If an error occurs during the
establishment of BGP adjacency, the
retry interval would have exponential
backoff. The maximum delay can be
160 seconds.
Maximum routemap length 81 32 Configures the maximum routemap
length when configured through
SNMP (not configurable).
BGP parameter default values
FastIron Ethernet Switch Software Upgrade Guide 13
53-1003089-02