Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 14)

The FastIron 08.0.xx release newly supports BGP4+(IPv6), IPv6 Multicast, Management VRF, and
Multi-VRF. There are also changes to BGP4 (IPv4), OSPFv2, OSPFv3, RIP, RIPng, and IP Multicast.
While some of these protocols are new to the FastIron family, some have been supported since Layer
3 routing has been supported. There are changes in the implementation to have a more unified CLI
and approach across the entire IP product portfolio.
For detailed information on the commands, configurations, and feature behaviors, see the FastIron
08.0.xx configuration guides.
For more information on supported features and platforms, see FastIron 08.0.xx release notes.
New or modified parameter values
The following sections cover the changes in the parameter values for various protocols in FastIron
08.0.xx as compared to FastIron 07.4.00:
NOTE
Only the parameters whose allowed value or range is changed have been listed.
Management parameter default values
Changes in management defaults TABLE 1
Parameter FastIron 08.0.xx FastIron 07.4.00
Maximum number of outbound Telnet sessions 5 1
Maximum number of outbound SSH sessions 5 1
Multicast parameter values
Changes in multicast parameter values TABLE 2
Parameter Device FastIron 08.0.xx(minimum/
maximum/default) FastIron 07.4.00(minimum/maximum/
default)
L2 Multicast
IGMP Group ICX 6430 256/4096/1024 256/1024/256
MLD Groups FCX 256/8192/4096 256/32768/8192
ICX 6610 256/8192/4096 256/32768/8192
SX Gen2 256/8192/4096 256/32768/8192
SX Gen3 256/8192/4096 256/32768/8192
ICX 6450 256/8192/4096 256/32768/8192
ICX 6430 256/4096/1024 256/1024/256
New or modified parameter values
12 FastIron Ethernet Switch Software Upgrade Guide
53-1003089-02