Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 27)

Deprecated PIM commands (Continued) TABLE 22
Command Note
[no] ip pim ttl-threshold ttl Configures Multicast TTL-threshold on a particular interface.
This feature was never supported in FastIron even though the command was
available. TTL threshold value of 1 was used internally. The behavior is same in
FastIron 08.0.00.
ip-multicast-disable Disables multicast routing and snooping on this particular interface or list of ports
within a virtual interface.
Show command
show ip pim error Displays PIM errors counters. In FastIron 08.0.xx, a new command show ip pim
counter displays the error counters.
Clear command
clear pim flow Clears all PIM flows from hardware.
Network Management
New network management commands TABLE 23
Command Note
show ip dns Shows the Domain List and IP address of the DNS server.
show ip dns-server domain-list Shows the Domain List of DNS servers.
show ip dns-server server-address Shows the IP addresses of DNS servers.
show ip ssl Displays the SSL connection in use.
show management-vrf Shows the Management VPN Routing/Forwarding (VRF) instance
information.
show ntp associations Shows NTP associations.
show ntp associations detail Shows NTP associations in detail.
show ntp associations detail Shows the IPv4 address of NTP server/peer.
show ntp associations detail Shows the IPv6 address of NTP server/peer.
show ntp status Shows the NTP Status information.
show snmp buffer Shows the SNMP buffer.
show cpu-utilization tasks Shows the CPU utilization.
show running-config vrf Shows the VRF-Lite running configuration.
Network Management
FastIron Ethernet Switch Software Upgrade Guide 25
53-1003089-02