Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 25)

Modified IGMP L3 routing commands (Continued) TABLE 19
FastIron 08.0.xx FastIron 07.4.00 Note
[no] ip igmp static-group
group-addr [ethernet ...]
[no] ip igmp static-group
group-addr [count num ]
[ethernet ...]
Configures a static member of an IGMP
group. In FastIron 08.0.xx, it does not
support specifying multiple contiguous
static groups using "count" option.
PIM
New PIM commands TABLE 20
Command Note
ipv6 pimsm-snooping Enables PIM6 SM snooping globally.
multicast6 pimsm-snooping Enables PIM6 SM snooping on the VLAN.
Show command
show ipv6 multicast pimsm-snooping Displays PIM6 SM snooping information.
show ip igmp [vrf vrf-name ] static Displays IGMP static membership information. The show ip igmp
group command also displays static IGMP membership
information.
Clear command
clear ipv6 multicast pimsm-snooping Clears PIM6 SM snooping information.
Modified PIM commands TABLE 21
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command
[no] hello-timer seconds
default: 30 secs
allowed range: [10 -3600]
secs
[no] hello-timer seconds
default: 60 secs
allowed range: [10 -3600] secs
Configures the hello timer. The default value has
been changed from 60 seconds to 30 seconds.
[no] nbr-timeout seconds
default: 105 secs
allowed range: [3 - 65535]
secs
[no] nbr-timeout seconds
default: 180 secs
allowed range: [60 - 8000]
secs
Configures the PIM neighbor timeout value. The
default value has been changed from 180 seconds
to 105 seconds and the allowed range has been
changed from [60-8000] seconds to [3-65535]
seconds.
[no] prune-wait seconds
default: 3 secs
allowed range: [0 - 30] secs
[no] prune-wait seconds
default: 3 secs
allowed range: [0 - 3] secs.
Configures the PIM prune wait timer. The allowed
range has been changed from [0-3] seconds to
[0-30] seconds.
PIM
FastIron Ethernet Switch Software Upgrade Guide 23
53-1003089-02