Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 24)

Modified MLD-Snooping commands (Continued) TABLE 17
FastIron 08.0.xx FastIron 07.4.00 Note
[no] system-max mld-
snoop-group-addr
num
[no] system-max mld-
max-group-addr
num
Sets the maximum limit for the MLD group
records.
VLAN level command
multicast6 mld-snooping Configures MLD snooping on a particular VLAN.
This command is now consistent with
IGMP
snooping command.
Show command
show ipv6 multicast show ipv6 mld-snooping Shows MLD snooping related information. This
command is now consistent with
IGMP
snooping command.
Clear command
clear ipv6 multicast clear ipv6 mld-snooping Clears MLD snooping mcache or counters. This
command is now consistent with
IGMP
snooping command.
IGMP (L3 Routing)
New IGMP L3 routing commands TABLE 18
Command Note
Show command
show ip igmp [vrf vrf-name ] static Displays IGMP static membership information. The show ip igmp
group command also displays static IGMP membership information.
Modified IGMP L3 routing commands TABLE 19
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command
[no] ip igmp group-
membership-time
seconds
default: 260 secs
allowed range: [5 -26000] secs
[no] ip igmp group-
membership-time
seconds
default: 260 secs
allowed range: [20 - 7200] secs
Configures IGMP group membership
times. The allowed range for time has
changed from [20 - 7200] to [5 - 26000].
Interface level command
[no] ip igmp port-version
version ethernet num
[no] ip igmp port-version
version ethernet num
Configures the IGMP version on a
physical port within a virtual routing
interface. The allowed IGMP version
range has changed from [2-3] to [1-3].
IGMP (L3 Routing)
22 FastIron Ethernet Switch Software Upgrade Guide
53-1003089-02