Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 16)

Changes in BGP, BGP4+, and Route Maps defaults (Continued) TABLE 3
Parameter FastIron 08.0.xx FastIron 07.4.00 Note
Default behavior for invalid
confederation as path Ignore Not ignored Not configurable.
Minimal route advertisement
interval 0 30 Configurable.
Maximum router advertisement
interval 3600 sec 600 sec Configurable.
Update time 0 - 30 sec 1 - 30 sec Configures iBGP route update
interval.
Maximum ECMP paths in BGP 8/6 (stackable and TI/
others) 8 Configures the number of ECMP
paths.
Minimum allowed update time 0 1 Not configurable.
Routes displayed per page 13 5 Not configurable.
Command changes
Several commands have been replaced or modified in FastIron 08.0.xx release. It is recommended to
use the new set of commands. The following sections summarize the differences in commands
between FastIron 08.0.xx and 07.4.00.
OSPFv2
New OSPFv2 commands TABLE 4
Command Note
Global level command (router OSPF and sub-command)
[no] router ospf vrf Configures OSPF instance with VRF index.
[no] default-passive-interface Sets OSPF interface passive.
[no] max-metric Configures Stub Router Advertisement.
[no] nonstop-routing Enables OSPF nonstop routing capability.
[no] nssa-translator Enables NSSA Type 7 to Type 5 LSA translation.
[no] vrf-lite-capability Configures CE Router VRF Lite capability (disable DN bit
checks).
cost ( area decimal range sub-command) Configures area range cost.
Command changes
14 FastIron Ethernet Switch Software Upgrade Guide
53-1003089-02