Brocade FastIron Ethernet Switch Software Upgrade Guide User Manual

Page 42

BOOT INFO: Become active CPU module

M2 BI Boot Code Version 07.06.05

Enter 'b' to go to boot monitor ...

BOOT MONITOR>

Set a temporary IP address of the same subnet as the TFTP server NIC, for the device
management port using the ip address command. For example:

BOOT MONITOR> ip address 10.10.10.2/24

BOOT INFO: set ip addr to 10.10.10.2, ip mask to 255.255.255.000

Test the connectivity from the device to the TFTP server using the ping command to ensure a
working connection. For example:

BOOT MONITOR> ping 10.10.10.1

Reply from 10.10.10.1 : bytes=100 time=1ms TTL=64

Enter the following command to boot from the image on a TFTP server that hosts a valid software
image:

boot system tftp ip-address image-file-name

For example:

Brocade # boot system tftp 192.168.1.200 FCXR08000.bin

You will get an output similar to the following:

BOOT MONITOR>

BOOT MONITOR> boot system tftp 192.168.1.200 FCXR08000.bin

BOOT INFO: try to boot thru tftp 192.168.001.200, FCXR08000.bin

BOOT INFO: tftp copy successful!

BOOT INFO: bootparam at 27ffffe0, mp_flash_size = 002d022b

BOOT INFO: code decompression completed

BOOT INFO: start with hardware reset

BOOT INFO: branch to 20000104

Reset all modules ...

Init Management module 1 ...

Init DMA 1.. 2.. 3.. 4..

Init module 5 ...

Init DMA 1.. 2.. 3..

Parsing Config Data ...

Load config data from flash memory...

Compiled on Apr 06 2013 at 20:13:29 labeled as FCXR08000

(2949675 bytes) from Tftp

Copy the image from the TFTP server to the primary and secondary flash partition using the copy
tftp flash ip-address image-file-name primary | secondary command. For example:

copy tftp flash 192.168.1.200 FCXR08000.bin primary

Enter the show flash command to check whether image copy process is successful.

10. Reboot the device using the reload command.

Software recovery on ICX 6430, ICX 6450, ICX 6650, ICX 7750, and
FSX devices

NOTE
In practice, the TFTP server is also used as terminal server to see the CLI output.

Connect a console cable from console port to the terminal server.

Connect Ethernet cable from the management port (port located under the console port on the
device) to the TFTP server.

Software recovery on ICX 6430, ICX 6450, ICX 6650, ICX 7750, and FSX devices

FastIron Ethernet Switch Software Upgrade Guide

53-1003089-02