Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 23)

Deprecated BGP and Route-Map commands (Continued) TABLE 13
Command Note
[no] set nlri [multicast | unicast] Configures the route map set rule with multicast or
unicast NLRI.
[no] neighbor peer-group update-source pos
interface
Configures the router to communicate with a neighbor
through specified interface.
ARP
Modified ARP commands TABLE 14
FastIron 08.0.xx FastIron 07.4.00 Note
[no] arp ip-addr mac-addr [ethernet
slot/port l vlan vlan-id ]
[no] arp num ip-addr mac-addr
ethernet port
For static ARP configuration, index
number in the CLI is not needed
anymore.
IGMP-Snooping
Modified IGMP-Snooping command TABLE 15
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command
[no] system-max igmp-snoop-
group-addr
num
[no] system-max igmp-max-
group-addr
num
Sets the maximum limit for the IGMP
group records.
Deprecated IGMP-Snooping command TABLE 16
Command Note
VLAN level command
[no] multicast static-group group-addr Configures static IGMP groups on entire VLAN.
MLD-Snooping
Modified MLD-Snooping commands TABLE 17
FastIron 08.0.xx FastIron 07.4.00 Note
Global level command
ipv6 multicast ipv6 mld-snooping Configures MLD snooping globally. This
command is now consistent with
IGMP
snooping command.
ARP
FastIron Ethernet Switch Software Upgrade Guide 21
53-1003089-02