Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 62)

show command output differences between 07.4.00 and 08.0.xx
show ipv6
interface
tunnel 2
Brocade#show ipv6 interface tunnel 1
Interface Tunnel 1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80::101:102 [Preferred]
Global unicast address(es):
2001:100::2 [Preferred], subnet is 2001:100::/64
2001:100:: [Anycast], subnet is 2001:100::/64
Joined group address(es):
ff02::1:ff00:2
ff02::1:ff01:102
ff02::16
ff02::d
ff02::1:ff00:0
ff02::2
ff02::1
Port belongs to VRF: default-vrf
MTU is 1480 bytes
ICMP redirects are disabled
No Inbound Access List Set
Outbound Access List
Anycast and VRF
information are
added.
show ip
ospf
routes
1.2.3.4 ?
Brocade#sh ip ospf route 192.190.101.0
Destination Mask Path_Cost Type2_Cost Path_Type
192.190.101.0 255.255.255.0 3 0 Intra
Adv_Router Link_State Dest_Type State Tag
Flags
192.168.98.190 192.168.98.190 Network Valid 0
0000
Paths Out_Port Next_Hop Type State
1 e 4/3/1 193.213.111.111 OSPF 29 a8
2 ve 17 192.213.111.111 OSPF 00 00
ARP index field is
deprecated.
show ipv6
cache 2
Total number of IPv6 and IPv6 VPN cache entries: 44
IPv6 Address Next Hop
Port
2 2000:824:824:824::8 DIRECT ve
824
3 fe80:512::512:1 LOCAL e
5/1/2
4 2000:202:202:202::1 LOCAL
loopback 2
5 2000:400:400:400::2 LOCAL ve
400
6 2000:824:824:824::4 LOCAL ve
824
7 2000:411:411:411::1 LOCAL e
1/1/1
8 2000:400:400:400::3 DIRECT ve
400
9 fe80:824::824:4 LOCAL ve
824
10 fe80:411::411:1 LOCAL e
1/1/1
11 2000:512:512:512::1 LOCAL e
5/1/2
12 fe80::234:ff:fe34:34 LOCAL
loopback 2
The output is
modified as
highlighted in red.
FastIron Ethernet Switch Software Upgrade Guide
53-1003089-01