Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 68)

show command output differences between 07.4.00 and 08.0.xx
show auth-
mac-
addresses
authorized-
mac ip-
addr
Brocade#sh auth-mac-addresses authorized-mac ip-add
-------------------------------------------------------------------------
------
MAC Address SourceIp Port Vlan Auth Age dot1x ACL
-------------------------------------------------------------------------
------
54d1.1896.0000 102.1.1.1 2/1/8 1006 Yes Ena Ena 103
The output is
displayed
differently. ACL
field is shown
before dot1x in
FastIron 07.4.00b.
show ipv6
interface
ethernet
1/1 ?
Interface Eth 1/1/1 is up, line protocol is up
IPv6 is enabled, link-local address is fe80:411::411:1 [Preferred]
Global unicast address(es):
2000:411:411:411::1 [Preferred], subnet is 2000:411:411:411::/64
2000:411:411:411:: [Anycast], subnet is 2000:411:411:411::/64
Joined group address(es):
ff02::1:ff00:1
ff02::1:ff11:1
ff02::16
ff02::d
ff02::1:ff00:0
ff02::2
ff02::1
Port belongs to VRF: default-vrf
MTU is 1500 bytes
ICMP redirects are disabled
ND DAD is enabled, number of DAD attempts: 3
ND reachable time is 30000 miliseconds
ND retransmit interval is 1000 miliseconds
ND advertised reachable time is 0 seconds
ND advertised retransmit interval is 0 miliseconds
ND router advertisements are sent every 113 seconds
ND router advertisements live for 1800 seconds
Hosts use stateless autoconfig for addresses
No Inbound Access List Set
Outbound Access List
"Port belongs to
VRF" information
is added.
FastIron Ethernet Switch Software Upgrade Guide
53-1003089-01