Brocade FastIron Ethernet Switch Software Upgrade Guide - Manual (Page 20)

New OSPFv3 commands (Continued) TABLE 7
Command Note
Interface level commands
[no] active Sets active status. FastIron 07.4.00 behavior was always
active.
[no] hello-jitter Configures jitter between HELLO packets, in percentage.
[no] suppress-linklsa Suppresses link LSA advertisements.
Show command
show ipv6 ospf summary Displays summary of IPv6 OSPF instances.
show ipv6 ospf vrf Displays IPv6 OSPF information for a VRF or all VRF
interfaces.
Clear command
clear ipv6 ospf route Clears OSPF routes.
clear ipv6 ospf vrf Clears OSPF all or specific data in a specific vrf.
Deprecated OSPFv3 commands TABLE 8
Command Note
Global level command (router OSPF and sub-command)
[no] virtual-link-if-address Configures source address to use with virtual links.
RIP
New RIP commands TABLE 9
Command Note
Global level command (router RIP and sub-command)
[no] learn-default Enables learning of RIP default routes.
[no] poison-local-routes Advertises local routes with maximum metrics when they go down.
Interface level commands
[no] ip rip learn-default Enables learning of RIP default routes from this interface.
RIP
18 FastIron Ethernet Switch Software Upgrade Guide
53-1003089-02