Yokogawa Button Operated MV2000 - Manual (Page 81)

4-8 M-4662
4.3 Setup Parameters
The measurement range and setup range of parameters used in a command vary
depending on the combination of the command, range, and options.
Examples of Entering Measurement Range Parameters
The span upper and lower limit parameters of the SR command (input range setting
command) requires all digits including fractional digits to be set. For example, if you want
to set the upper limit to 1.0000 V when the measurement range is –2.0000 V to 2.0000 V,
specify 10000. If you want to set the limit to 0.5000 V, specify 5000.
The table below gives examples.
Measurement
Range Input Type
Parameter Selectable Range of
Measurement Range The Range You Want to Set Parameter
VOLT 20mV -20.000mV to 20.000mV -10.000mV to 20.000mV -10000 to 20000
/SQRT 2V -2.0000V to 2.0000V -2.0000V to 0.5000V -20000 to 5000
TC R 0.0 to 1760.0 0.0 to 400.0 0 to 4000
K -200.0 to 1370.0 -200.0 to 1370.0 -2000 to 13700
RTD Pt100 -200.0 to 600.0 -10.0 to 500.0 -100 to 5000
DI LEVEL 0 to 1 0 to 1 0 to 1
Measurement Range Parameters
The table below shows the relationship between the input types and range parameters.
For the selectable range, see the RD-MV1000/RD-MV2000 User’s Manual (IM RD-
MV1000-01E).
Input Type Input Type
Parameter Range Range
Parameter Required
Option
DC voltage VOLT 20mV 20MV
60mV 60MV
200mV 200MV
2V 2V
6V 6V
20V 20V
50V 50V
Thermocouple TC R R
S S
B B
K K
E E
J J
T T
N N
W W
L L
U U
Kp vs Au7Fe KP /N3
PLATINEL PLATI /N3
PR40-20 PR /N3
NiNiMo NIMO /N3
WRe WRE
W/WRe26 W/WRE /N3
TypeN(AWG14) N2 /N3
RTD RTD Pt PT
JPt JPT
Pt50 PT50 /N3
Ni100(SAMA) NI1 /N3
Ni100(DIN) NI2 /N3
Ni120 NI3 /N3
J263*B J263 /N3