Yokogawa Button Operated MV2000 - Manual (Page 25)

M-4662 2-11
Using
the
Ethernet
Interface
1
2
3
4
5
6
7
App
Index
Setting the POP3 Server Connection
Specify the operation for connecting to the POP server.
◊ Press MENU and then select Menu tab > Basic setting mode > Environment tab >
Communication > POP3 Details
Send delay [second]
Enter the wait time from POP3 server authentication until transmission. Set a value in the
range of 0 to 10 (seconds).
POP3 Login
To send the POP3 server login password without encryption, set POP3 Login to PLAIN.
To send the password with encryption, set POP3 Login to APOP.
E-mail Test
◊ Press FUNC and then select E-mail test > Recipient1 or Recipient2
You can send a test e-mail to check the e-mail settings.
Enabling/Disabling the E-mail Transmission Function
Enabling the E-mail Transmission Function
◊ Press FUNC and then select E-Mail start
The e-mail transmission function is enabled.
Disabling the E-mail Transmission Function
◊ Press FUNC and then select E-Mail stop
The e-mail transmission function is disabled. Unsent e-mail messages are discarded.
E-mail Retransmission
If an e-mail transmission fails, the MV retransmits the message up to three times at
30-s, 1-minute, or 3-minute intervals. If retransmission fails, the MV discards the e-mail
message.
2.3 Sending E-mail Messages