Yokogawa Button Operated MV2000 - Manual (Page 23)

M-4662 2-9
Using
the
Ethernet
Interface
1
2
3
4
5
6
7
App
Index
Basic Settings
Specify the SMTP server and POP before SMTP.
• SMTP server name
Enter the host name or IP address of the SMTP server.
• Port number
Unless specified otherwise, set the number to the default value. The default value is
25.
• Security
If you need to use POP before SMTP, set Security to PbS.
Recipients
Set the recipient e-mail addresses.
• Recipient 1 and Recipient 2
Enter e-mail addresses. You can enter multiple addresses in each recipient box.
Separate each address with a space. You can enter up to 150 characters.
• Sender
Enter the sender e-mail address. You can enter up to 64 characters.
POP3 Settings
If you need to use POP before SMTP, specify the POP3 server.
For the POP3 login procedure, see “Setting the POP3 Server Connection” in this section.
• POP3 Server name
Enter the host name or IP address of the POP3 server.
• Port number
Unless specified otherwise, set the number to the default value. The default value is
110.
• Login name
Enter the POP3 server login name.
• Password
Enter the POP3 server login password. You can enter up to 32 characters.
Alarm Settings
Specify the settings for sending e-mail when alarms occur or clear.
• Recipient 1 and Recipient 2
Specify the recipients. For Recipient 1 and Recipient 2, select On to send e-mail or
Off to not send e-mail.
• Active Alarms
Sends an e-mail when an alarm occurs or clears. For alarms 1 to 4, select On to send
e-mail or Off to not send e-mail.
• Include INST
Select On to attach instantaneous value data that is acquired at the time of alarm
occurrence.
• Include source URL
Select On to attach the source URL. You can attach the URL when the Web server is
enabled.
• Subject
Enter the subject of the e-mail using up to 32 alphanumeric characters. The default
subject is Alarm_summary.
• Header 1 and Header 2
Enter Header 1 and Header 2 using up to 64 characters.
2.3 Sending E-mail Messages