ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 68)

C HAPTER 3 D ISASSEMBLY P ROCEDURES
62 9650-001356-01 Rev. D
• Kapton tape
• 3M copper adhesive tape, or equivalent
• Large diagonal cutters
Safety Precautions
WARNING! SHOCK HAZARD!
Caution TAKE THE NECESSARY PRECAUTIONS TO GUARD AGAINST SHOCK OR INJURY
BEFORE YOU CONDUCT DEFIBRILLATOR TESTS OR REPAIRS.
• Only properly trained technicians should service the unit.
• The unit can contain deadly voltages even if the unit is turned off.
• Make sure to discharge the unit before working with it.
• Make sure you take the necessary precautions when working with static sensitive units. For
example, you must wear a conductive wrist strap (which touches your skin) connected to a
grounding mat and to the earth ground. You must remove the wrist strap when you discharge
high voltage or when you are working on energized equipment.
Modules
The X Series unit contains the following ten (10) modules or assemblies:
• Printer
• Front Enclosure
• Display
• NIBP
• EtCO
2
(Oridion
®
)
• Monitor Board
• Capacitor Bank
• Defibrillator Board
• SpO
2
• CP Carrier Module
These modules can be purchased as replacement parts from the ZOLL Technical Support
Department. See Chapter 4, "Replacement Parts" for information on ordering replacement
parts.