Vanguard ATRT-03_03B S2 - Manual (Page 42)

ATRT-03 S2, ATRT-03A S2, AND ATRT-03B S2 USER’S MANUAL REV 2
37
NOTE
The above screen will be displayed if there is currently no data in the unit’s
memory buffer. If a test was previously performed or a test record was
restored from Flash EEPROM or from a Flash drive, the following screen will
be displayed instead:
Press the [1] key (APPEND PREV. DATA) to append the data in the unit’s
working memory to the current test results, or press the [2] key (CLEAR PREV.
DATA) to clear any previous data from the unit’s memory buffer and only save
the current test results.
The following screen will then be displayed:
Press any key to continue.
j. The following screen will be displayed:
Press the
[2]
key (NO).
RUN ANOTHER TEST?
1. YES
2. NO
3. REPEAT PREV. TEST
TEST SAVED
PREVIOUS DATA IN BUF
1. APPEND PREV. DATA
2. CLEAR PREV. DATA