Vanguard ATRT-03_03B S2 - Manual (Page 109)

REV 2 ATRT-03 S2, ATRT-03A S2, AND ATRT-03B S2 USER’S MANUAL
104
3.6.6. Saving a Test Plan
Use the steps below to save a test plan from the working memory to the unit’s Flash EEPROM
or to a connected USB Flash drive:
a. Make sure a test plan is loaded in the working memory, and then start from the “START-
UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the [6] key (SAVE TEST PLAN).
If a USB Flash drive is connected to the unit, continue to step c.
If a USB Flash drive is NOT connected to the unit, continue to step d.
c. The following screen will be displayed:
1. SAVE INTERNALLY
Press the [1] key (SAVE INTERNALLY) to save the test plan to the unit’s Flash
EEPROM. Continue to step d.
2. SAVE TO THUMB DRIVE
Press the [2] key (SAVE TO THUMB DRIVE) to save the test plan to the connected
USB Flash drive. The test plan will be saved to the USB Flash drive and the
following screen will be displayed:
1. SAVE INTERNALLY
2. SAVE TO THUMB DRIVE
1. LOAD TEST PLAN
2. UNLOAD TEST PLAN
3. PLAN DIRECTORY
4. PRINT TEST PLAN
5. ERASE TEST PLAN
6. SAVE TEST PLAN
7. COPY TO THUMB DRIVE
1. RUN TEST
2. SETUP
3. TEST PLANS
4. DIAGNOSTIC
TIME: 15:45:15
DATE: 07/20/10