Vanguard ATRT-03_03B S2 - Manual (Page 111)

REV 2 ATRT-03 S2, ATRT-03A S2, AND ATRT-03B S2 USER’S MANUAL
106
3.6.7. Copying a Test Plan to a USB Flash Drive
Use the steps below to copy a test plan from the unit’s Flash EEPROM to a connected USB Flash
drive:
a. Make sure a USB Flash drive is connected to the unit’s “USB MEM” port, and then start
from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
ATRT-03 S2 and ATRT-03A S2 ATRT-03B S2
Press the
[7]
key. Press the
[6]
key.
c. The following screen will be displayed:
Type the test plan number using the alpha-numeric keypad and then press the
[ENTER]
key.
d. The selected test plan will be copied to the USB Flash drive and the following message
will be displayed:
ENTER TP NUMBER
TO COPY TO FLASH DRV
TP NUMBER:
1. LOAD TEST PLAN
2. UNLOAD TEST PLAN
3. PLAN DIRECTORY
4. ERASE TEST PLAN
5. SAVE TEST PLAN
6. COPY TO THUMB DRIVE
1. LOAD TEST PLAN
2. UNLOAD TEST PLAN
3. PLAN DIRECTORY
4. PRINT TEST PLAN
5. ERASE TEST PLAN
6. SAVE TEST PLAN
7. COPY TO THUMB DRIVE
1. RUN TEST
2. SETUP
3. TEST PLANS
4. DIAGNOSTIC
TIME: 15:45:15
DATE: 07/20/10