Ransburg RCS 2 Ratio Control System - Manual (Page 46)

INPUTS:
Strobe Gun 1
Strobe Gun 2
Strobe Gun 3
Strobe Gun 4
Strobe Gun 5
Strobe Gun 6
Strobe Gun 7
Strobe Gun 8
Job #[1]
Job #[2]
Job #[4]
Job #[8]
Job #[10]
Job #[20]
Job #[40]
Job #[80]
Job #[100]
System Spare 1
System Spare 2
System Spare 3
OUTPUTS:
System Fault
System Pulse
System User Link
Option 3 - Analog Inputs and Outputs
INPUTS:
Flow Rate Setpoint
Actual Flow Rate
Motor RPM
Solvent Flow Rate
Hardener Flow Sensor
Feather Pressure
Inlet Pressure
Outlet Pressure
OUTPUTS:
Actual Flow Rate
Motor RPM
Pressure Control
On all of the Force I/O screens, there are 3 function
buttons defined:
F1: Toggle On/Off or Modify Force - This but-
ton allows the user to toggle forces on and off. If
the parameter requires a numeric input, a popup
keypad is displayed. (User must first use the F2
button to enable the force prior to using this key.)
F2: Toggle Force - This button allows the user
to enable or disable the particular force under
the cursor. A letter F in parenthesis will appear if
the force is enabled next to the value in that cell.
F3: Reset All - This button allows the user to
remove all forces for the displayed screen. To
reset all forces (gun, system, and analog) user
must go to each of the three screens and push
the F3 button.
F8: Plot Data
This feature allows operators to generate a graph
of many of the process variables to monitor the
response of the system as it relates to time. Up
to 4 var-iables from any of the configured guns
can be graphed at any one time. All 4 variables
to be graphed do not need to be from the same
gun. (e.g. The triggers of 4 guns can be graphed
at the same time.)
RCS-2 User Manual - Operation
43 LN-9407-00.2
Ransburg