Burkert Type 8175 - Manual (Page 84)

16
8175
ENGLISH
INSTALLATION
N
L1
+ -
- +
4 3 2 1
115/230 VAC
N
L1
REL1
REL2
N
L1
+ -
- +
4 3 2 1
115/230 VAC
N
L1
REL1
REL2
Wiring of the 115/230 VAC version
Remove the cover via the screws on the front display and pull the cable through the cable
gland and wire according to one of the pin assignment diagrams below.
The electronics within the 8175 allows a sourcing or sinking PLC to be connected. Position
A (Fig 3.5) provides a sourcing configuration and Position B (Fig 3.6) a sinking configurati-
on.
- Do not open and wire the transmitter with the power supply connected.
- Ensure that the power supply switch is selected for the appropriate
voltage 115VAC or 230 VAC.
The connection for relays 1 and 2 are identical to that of the 18-32VDC on the previous
page.
Fig. 3.8 Pin assignment, Position A Fig. 3.9 Pin assignment, Position B
SW 2,
Position A
SW 2,
Position B
Fuse - 5A
Fuse - 5A
PLC/control valve/
positioner
4-20mA
Power Supply switch
Fuse - 250 mA T
Red wire
Black wire
Green&yellow
wire
Red wire
Green&yellow wire
Black wire
Fuse - 250 mA T
PLC/control valve/
positioner
4-20mA