Burkert Type 8619 - Manual (Page 73)

71
Adjustmentandcommissioning
8.10.19. choosing the units for the totalizers
The function is available if the software option "FLOW" is activated. See chap. 8.10.4.
Refer to chap. 8.9 to access Parameters menu.
This is
when the
device is be-
ing parame-
tered............
....................
Parameters
This is
when the
device is be-
ing parame-
tered............
....................
M0:Inputs DI1/DI2 Totalizer A unit
Totalizer B unit
Mx:Inputs
The function makes it possible to select the units of the totalizers.
8.10.20. configuring the analogue inputs
Refer to chap.8.9 to access Parameters menu.
AI1/AI2 Mode:
Current
None
Voltage
Range: 0-20mA
Format: 0
20 mA: ENTERING
Unit: Unit list
Manual entry
This is
when the
device is be-
ing parame-
tered............
....................
Mx:Inputs
0-5V
0-10V
4-20mA
if "Mode" = "Current"
if "Mode" = "Voltage"
0.00
0.000
0.0
0 mA / 4 mA: ENTERING
Filter:
Fast
None
Slow
5V / 10V: ENTERING
0V: ENTERING
if "Mode" = "Current"
if "Mode" = "Voltage"
This is
when the
device is be-
ing parame-
tered............
....................
Parameters
MODE: Choose the input signal type, current or voltage.
RANGE: Choose the range of the input signal, depending on the choice made in "MODE".
FORMAT: Choose the number of displayed decimals.
UNIT: Choose the units of the process input associated to the input signal within a predefined list or enter it.
0/4MA: Enter the value of the previously selected process variable, which is associated to a 0/4 mA input current.
Instead of being entered, the value can be automatically determined using the function "PV calibration" in the
menu "Calibration -> Mx:Inputs -> AI1 or AI2". See chap. 8.11.4.
20MA: Enter the value of the previously selected process variable, which is associated to a 20 mA input current.
Instead of being entered, the value can be automatically determined using the function "PV calibration" in the
menu "Calibration -> Mx:Inputs -> AI1 or AI2". See chap. 8.11.4.
Type 8619
english