Burkert Type 8619 - Manual (Page 130)

128
Maintenanceandtroubleshooting
message
displayed meaning recommended action
"Memory card
read" The file with the saved data is corrupted.
→
Use another file.
«File open» The file with the saved data cannot be read:
• either because the two devices are not
compatible.
• or, because the data saving failed.
To check the compatibility between the
devices:
→
save the data of both devices (on
two different memory cards),
→
check that the file names are the
same.
→
if the file names are different, enter
the configuration by hand.
«Incompatible
module» You are trying to transfer data saved from a module
to a module of different type (e.g. the data saved
from a pH module to a conductivity module).
→
Load data to a module of the same
type.
9.3.8. messages during datalogging (icon X displayed)
The error messages associated to the icon X , can be generated during datalogging (see chap. 8.10.18).
Message displayed in the system
log Signification recommended action
"M0:MC read only" The card is write protected. Authorize writing on the card by
pushing the load lever.
"M0:MC failure" Problem on the memory card. • Make sure there is a memory card in
the device.
• Format the memory card.
• If the problem persists, change the
memory card.
"M0:MC full" The memory card is full. • Insert an empty memory card or
delete data on the current card.
• If the problem persists, format the
card using a PC.
• If the problem persists, change the
memory card type.
"M0:MC data loss" The card was removed when the
datalogger was "ON"
Data is lost.
Always deactivate the datalogger
before removing the memory card from
the device (see chap. 8.10.18).
9.3.9. miscellaneous messages
Message displayed in the system log Meaning recommended action
"M0:Power on" The device is switched on. -
Type 8619
english