Burkert Type 8619 - Manual (Page 103)

101
Adjustmentandcommissioning
• The "warning" event may also be associated with one and/or other digital outputs. See chap. 8.10.22.
• A current of 22 mA may be emitted on one and/or other of the current outputs when an "error" event related
to either the monitoring of the fluid pH, redox, conductivity or temperature values or the monitoring of an
analogue input is generated. See chap. 8.10.21 to activate the mode.
• See also "If you encounter problems", chap. 9.3
STATUS: Choose whether or not to activate monitoring of the fluid temperature.
This monitoring is done by the generation of a "warning" event if the fluid temperature range defined in the "Warn
Hi/Lo" functions below is exceeded and an "error" event if the fluid temperature range defined in the "Err Hi/Lo"
functions below is exceeded.
TEMPERATURE: Read the fluid temperature measured in real time by the temperature sensor.
WARN. HIGH: Enter the fluid temperature value above which a "warning" event is generated.
WARN. LOW: Enter the fluid temperature value below which a "warning" event is generated.
ERR. HIGH: Enter the fluid temperature value above which an "error" event is generated.
ERR. LOW: Enter the fluid temperature value below which an "error" event is generated.
8.12.7. reading the parameters of the ph, redox or conductivity
sensor
Refer to chap. 8.9 to access the Diagnostics menu.
Diagnostics Monitor Mx:pH/ORP READING
Mx:Conductivity
8.13. Tests menu
8.13.1. modifying the "Tests" menu access code
Refer to chap. 8.9 to access "Tests" menu. If the default access code "0000" is kept, the device does not request
it to access the "Tests" menu.
Tests System Code 0*** Confirm code 0***
Enter the new
"TESTS" menu
access code Confirm the new
code
Type 8619
english