Burkert Type 8619 - Manual (Page 53)

51
Adjustmentandcommissioning
Refer to chap. 8.9 to access Parameters menu.
Parameters Functions F1...F6: Type: ONOFF
Name:
Status:
ENTERING
ON
OFF
PV:
1)
M1:
M0:MAIN
Mx:
...
SP Value: ENTERING
CMDSafe:
Inversion ON
OFF
Hysteresis ENTERING
PreBleed:
PV range PVScale-:
PVScale+:
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
ENTERING
ENTERING
MaxONtime: Status:
Value
ON
OFF
ENTERING
Mode
Value
ON
OFF
ENTERING
Status:
PB Limit ch1:
ON
OFF
ENTERING
PB Limit ch2: ENTERING
PV filter: None
Fast
Slow
1) The choices offered depend on the modules fitted and/or the options activated. See chap. 8.10.4 and chap. 8.16.
TYPE: Indicates the function chosen.
NAME: Rename the function chosen. See chap. 8.4. This name appears in the view associated with this function
in Process level.
STATUS: Used to activate (choose "ON") or deactivate (choose "OFF") the function selected.
PV: Choose the process input for the function from the list suggested by the device. This process input may be a
measured physical parameter, an analogue output or the result of another active configured function.
SP VALUE: Enter the setpoint value.
PV RANGE: Enter the minimum ("PVScale-" ) and maximum ("PVScale+") values of the process input.
PV FILTER: Choose the level of damping of the chosen process value. See Figure 29.
HYSTERESIS: Enter a hysteresis value for the switching point.
INVERSION: Used to invert (choose "ON") or not (choose "OFF") the operating direction of switching. See
Figure 40.
Type 8619
english